Honeywell RTH230B упутство за употребу

Honeywell RTH230B
9.2 · 2
PDF упутство за употребу
 · 4 странице/а
Енглески Језик
упутство за употребуHoneywell RTH230B
RTH230B 69-1800 2/6/05 1/4
The RTH230B programmable thermostat can be used to control:
a gas, fuel oil or electric furnace - 2 or 3 wires
a central air conditioner - 2 or 3 wires
a hot water system with or without pump - 2 wires
a millivolt system - 2 wires
a central heating and cooling system - 4 or 5 wires
Note: These thermostats are not compatible with heat pumps or
multi-stage systems.
Features
System operating mode selection: heat, cool or off
Fan operating mode selection: automatic or on (continuous)
Programmable heating and cooling cycle lengths: 10, 12, 15, 20
or 30 minutes
Temperature display in °F or °C
Battery replacement indicator
5-2 programming including:
- Preprogrammed energy-saving schedule
- Early Start
- Temporary bypass
- Time display (12 h or 24 h)
Filter replacement indicator

2.1 Removing the Old Thermostat

IN ORDER TO AVOID ANY RISK OF ELECTRIC SHOCK, CUT
POWER TO THE HEATING SYSTEM.

n Remove the old thermostat to access the wires.

Warning: If the old thermostat was mounted onto an electrical box,
it was probably powered by 120/240 volts. In this case, this thermo-
stat cannot be used.
o Identify and label each wire (with the corresponding letter on
the wire terminal) and remove them from the terminals.

p If necessary, strip the end of each wire (maximum of 1/4 inch).

q Wrap the wires around a pencil to prevent

them from falling into the wall.

r If the hole in the wall is too big, insulate it

using a non-flammable material in order to
avoid air draughts behind the thermostat.

2.2 Installing the New Baseplate

For a new installation, choose a location approximately 5 feet
(1.5 m) above the floor and on an inside wall. Avoid draughty
areas (top of staircase, air outlet, etc.), dead air spots (behind
doors), direct sunlight or areas near concealed pipes or chim-
neys.

n Remove the thermostat faceplate.

o Loosen the locking screw to separate the thermostat from its

baseplate (the screw cannot be completely removed).

p Tilt the thermostat upwards.

q Mark and bore the appropriate mounting holes (or use the

existing holes). Insert the plastic anchors.

r Pass the wires through the opening of the baseplate and fix the

baseplate to the wall using the screws provided.

2.3 Connecting the Thermostat

The connection of the new thermostat should be similar to that of
the old thermostat; however, it can vary depending on the installa-
tion.
Note: The red jumper wire between the Rc and Rh terminals must
be removed in 2- or 5-wire installations. The jumper must be used in
3- or 4-wire installations if you wish to use the mode selector switch
for the fan.

1. Introduction

2. Installation

RTH230B

Programmable Electronic Thermostat

Installation and User Guide

Display
Adjustment
buttons
System operating
mode selector
Fan operating
mode selector
Programming
buttons
Rh Heating power supply
Rc Cooling power supply
W Heating signal
Y Cooling signal
GFan

Погледајте упутство за употребу за Honeywell RTH230B овде, бесплатно. Ово упутство за употребу спада у категорију термостат и оценило га је 2 људи са просеком од 9.2. Ово упутство за употребу је доступан на следећим језицима: Енглески Језик. Имате ли питање о Honeywell RTH230B или вам треба помоћ? Овде поставите своје питање

Потребна вам је помоћ?

Имате ли питање о Honeywell и није ли одговор у упутству за употребу?

  • Примајте ажурирања о решењима
  • Добијajте одговоре на своје питање

Питање и одговор

Број питања: 0

Honeywell RTH230B termostat je digitalna kontrolna jedinica za grejanje i hlađenje prostorija u zgradama. Termostat ima programabilne podešavanja za vreme, temperaturu i dane u nedelji, tako da se može koristiti za automatizaciju temperature u prostoriji. Uredjaj meri trenutnu temperaturu sobe i upravlja HVAC sistemom da pravilno hladne ili greju prostoriju. Platforma termostata kompatibilna je sa većinom tipova HVAC sistema, tako da se može prilagoditi svakom električnom vodjenom grejnom ili hladnjenom sistemima poput radijatora ili centralnim klima uređajima. Uređaj je opremljen velikim ekranom koji prikazuje trenutnu temperaturu i mesto gde je uređaj postavljen. Uređaj poseduje dugme i opciju za snimanje nove postavke temperature, što omogućava korisnicima da brzo i lako povećaju ili smanje temperaturu u sobi. Uz sve navedeno, Honeywell RTH230B termostat je jednostavan za instalaciju i lako se može koristiti u kućnim i komercijalnim prostorima.

Општа питања
МаркаHoneywell
МоделRTH230B
Производтермостати
ЈезикЕнглески Језик
Тип датотекеУпутство за коришћење (PDF)

Не можете да пронађете одговор на своје питање у упутству за употребу? Одговор на своје питање можете пронаћи у честим питањима о Honeywell RTH230B испод.

Које је најбоље место за постављање термостата?

Најбоље место за термостат је соба у којој проводите највише времена, у многим случајевима је то дневни боравак или кухиња. Поставите термостат око један и по метар изнад пода, не на сунцу и не на вањском зиду.

Која је мртва трака термостата?

Ако ваш термостат има мртву траку, ваша инсталација је, такорећи, 'у мировању'. Термостат се укључује само када је, на пример, разлика одступа више од 2 ˚C од подешене собне температуре.

Која је идеална собна температура?

Већина људи сматра да је идеална собна температура између 19 и 22 степена Целзијуса.

Да ли је упутство за употребу за Honeywell RTH230B доступно на Српски?

Нажалост, немамо упутство за употребу за Honeywell RTH230B доступно на Српски. Ово упутство за употребу је доступно на Енглески Језик.

Зар ваше питање није наведено? Овде поставите своје питање

Нема резултата